LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2009 >> SLK55 >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - 171 Chassis >> Testing & Repair >> Remove/install left front or right RPM sensor - AR42.30-P-0712V

Remove/install left front or right RPM sensor - AR42.30-P-0712V

MODEL 171.442 /454 /456 /473 

Shown on left RPM sensor 

Fig 1: Identifying Left Front Or Right RPM Sensor Components
G05027645Courtesy of MERCEDES-BENZ USA
MODIFICATION NOTES

19.6.06 Tightening value of self-locking nut of suspension strut to upper steering knuckle changed Figure modified for model 171 *BA32.25-P-1010-01B 
REMOVINGINSTALLING Remove/install    
DANGER Risk of death  caused by vehicle slipping or toppling off of the lifting platform. Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. -
1 Raise vehicle with lifting platform   AR00.60-P-1000V
2 Remove the front wheels    
REFER TO MAINTENANCE Remove/install wheels, rotate if necessary   AP40.10-P-4050V
3 Remove rear section of fender liner (6) in front fender   AR88.10-P-1300V
4 Disconnect electrical connector (4) of left front RPM sensor (L6/1) at front axle electrical distributor   AR33.10-P-0100-06V
5 Unclip electrical feed line from left front RPM sensor (L6/1) from the retaining clamp (7) IMPORTANTInstallation:  Ensure lines are installed correctly.  
6 Support steering knuckle (8) with COMMERCIALLY AVAILABLE TOOLS transmission lifter and COMMERCIALLY AVAILABLE TOOLS transmission platform and lash securely COMMERCIALLY AVAILABLE TOOLS Transmission jack *WE58.40-Z-1030-11A 
    COMMERCIALLY AVAILABLE TOOLS Passenger car transmission platform *WE58.40-Z-1018-11A 
7 Unscrew bolts (5) from suspension strut (1) on steering knuckle (8) TORQUE SPECIFICATION *BA32.25-P-1008-01B 
8 Remove bolt (3) from steering knuckle (8) IMPORTANT The bolt and nut without collar must be replaced. The washers are discontinued.
Tightening torque only valid for threaded connection with collar.
 
    TORQUE SPECIFICATION *BA32.25-P-1010-01B 
9 Unscrew bolt (2) of left front RPM sensor (L6/1) TORQUE SPECIFICATION *BA42.30-P-1001-01A 
10 Pull left front RPM sensor (L6/1) out of steering knuckle (8)    
11 Install in the reverse order    
12 Read out fault memory    
REFER TO SELF-DIAGNOSTIC SYSTEMS Connect STAR DIAGNOSIS and read out fault memory   AD00.00-P-2000-04A
    STAR DIAGNOSIS diagnosis system *WH58.30-Z-1048-13A 
FRONT AXLE SHOCK ABSORBER

Number Designation Model 171
BA32.25-P-1008-01B Self-locking bolt, suspension strut to steering knuckle at bottom   Nm 110
BA32.25-P-1010-01B Self-locking nut, suspension strut to steering knuckle at top Stage 1 Nm 100
Stage 2 ∠° 90
FRONT AXLE RPM SENSOR

Number Designation Model 171
BA42.30-P-1001-01A Self-locking bolt, front axle RPM sensor to steering knuckle Nm 25
COMMERCIALLY AVAILABLE TOOLS

Number Designation
WH58.30-Z-1048-13A STAR DIAGNOSIS diagnosis system, Compact Passenger Car 6511 1801 00
WORKSHOP EQUIPMENT

WE58.40-Z-1018-11A Transmission platform
WE58.40-Z-1030-11A Transmission jack