Remove/install hand brake lever - AR42.20-P-0500V
MODEL 171.4
| Remove/install | |||
|---|---|---|---|
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. | - | |
| Notes on repairs to brake system | AH42.00-P-0003-01A | ||
| 1 | Release parking brake | ||
| 2 | Hoist vehicle with lifting platform until wheels are free | AR00.60-P-1000V | |
| 3 | Unhook rear parking brake cables from the front parking brake cable | AR42.20-P-0520-03VH | |
| Fig 2 | |||
| 4 | Remove center console with stowage compartment (1) | AR68.20-P-2000V | |
| 5 | Remove parking brake indicator switch (S12) | AR42.20-P-0501V | |
| 6 | Unscrew bolt (2) | *BA42.20-P-1003-01A | |
| 7 | Unhook cable (75a) from parking brake lever (75) at front parking brake cable | AR42.20-P-0520-03VV | |
| 8 | Remove parking brake lever (75) | ||
| 9 | Install in the reverse order | ||
| 10 | Operate parking brake lever (75) several times | ||
| Checking | |||
| 11 | Check operating travel of parking brake lever (75) and unobstructed movement of the rear wheels | Number of notches at which the parking brake must be adjusted if up to that point there is insufficient braking effect |
*BE42.20-P-1005-01A |
| Adjust parking brake | AR42.20-P-0540V |
TEST VALUES FOR PARKING BRAKE
| Number | Designation | Model 171 |
|---|---|---|
| BE42.20-P-1005-01A | Number of notches at which the parking brake must be adjusted if up to that point there is insufficient braking effect | 5 |
PARKING BRAKE
| Number | Designation | Model 171 | |
|---|---|---|---|
| BA42.20-P-1003-01A | Bolt, hand brake lever at transmission tunnel | Nm | 23 |