Remove/install thrust arm - AR35.20-P-0113V
MODELS 171.442 /454 /456 /473
Illustrated on model 171.442
| Remove/install | |||
|---|---|---|---|
| Risk of death due to the vehicle slipping off or toppling off the lifting platform | Align vehicle between the columns of the lifting platform and position the four support plates below the hoist support points specified by the vehicle manufacturer. | - | |
| 1 | Raise vehicle with lifting platform | AR00.60-P-1000V | |
| 2 | Remove wheel. | ||
| Remove/install wheels, rotate if necessary | AP40.10-P-4050V | ||
| 3 | Detach thrust arm (5) from wheel carrier | *BA35.20-P-1003-05A | |
| 4 | Detach thrust arm (5) from rear axle carrier | *BA35.20-P-1001-05A | |
| 5 | Install in the reverse order |
TORQUE STRUT
| Number | Designation | Model 171 | |
|---|---|---|---|
| BA35.20-P-1001-05A | Self-locking nut, torque strut to rear axle carrier | Nm | 50 |
| ∠° | 45 | ||
| BA35.20-P-1003-05A | Self-locking nut, thrust arm to wheel carrier | Nm | 50 |
| ∠° | 45 | ||