LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2009 >> SLK300 Standard >> Repair and Diagnosis >> Collision >> General Collision Information >> Rear Wall & Rear End >> Testing & Repair >> Replace bottom rear center section together with rear cross member - AR64.20-P-1060V >> Prepare rear center section with cross member - AR64.20-P-1060-05V

Prepare rear center section with cross member - AR64.20-P-1060-05V

COMMERCIALLY AVAILABLE TOOLS

Number Designation
WH58.30-Z-1001-03A Round wire brush, braided, dia. 70 mm
WH58.30-Z-1024-04A Abrasive disk, dia. 115 mm, 80 m/s (max. 13, 250 rpm)
WORKSHOP EQUIPMENT

WE58.40-Z-1001-03A Drill (electric/pneumatic)
WE58.40-Z-1003-03A Angle grinder (electric/pneumatic)
REPAIR MATERIALS

Number Designation Order number
BR00.45-Z-1001-07A Zinc dust paint suitable for spot welding A 000 986 34 42
  1. Grind connection surfaces on rear center section (1) down to bare metal in shaded areas.

    IMPORTANT Sand spot weld flanges down to bare metal on both sides.

  2. Coat insides of spot weld flanges with zinc dust paint.
    Fig 1: Identifying Connection Surfaces On Rear Center Section (Shaded Areas)
    G05028249Courtesy of MERCEDES-BENZ USA
  3. Grind connection surfaces on cross member (2) down to bare metal in shaded areas.

    IMPORTANT Sand spot weld flanges down to bare metal on both sides.

  4. Coat insides of spot weld flanges with zinc dust paint.
    Fig 2: Identifying Connection Surfaces On Cross Member (Shaded Areas)
    G05028267Courtesy of MERCEDES-BENZ USA
scientia non olet · About LEMON Manuals