Arrangement and assignment of Z connector sleeves (solder splices in wiring harness) - engine compartment (left) - GF00.19-U-3000-01TA
MODEL 171
Fig 1: Identifying Arrangement And Assignment Of Z Connector Sleeves (Solder Splices In Wiring Harness) - Engine Compartment (Left)
| Z conn. sleeve | Designation | Comp. | Designation | Conn. pin | |
|---|---|---|---|---|---|
| Z7/36z3 | Circuit 87 M2e connector sleeve | ← N10/1 | Driver-side SAM control module with fuse and relay module | 2.2 | |
| → M4/7 | Electric suction fan engine and AC with integrated control | 3 | |||
| → Y58/1 | Purge control valve | 2 | |||
| → Y58/4 | Activated charcoal filter shutoff valve | 1 | |||
| M272 | → Z7/36z2 | Circuit 87 M2e connector sleeve | |||
| Z36/12 | Headlamp range adjustment (HRA [LWR]) control bus connector sleeve | → E1 | Left front headlamp unit | 4.2 | |
| → E2 | Right front headlamp unit | 4.2 | |||
| → N71 | Headlamp range adjustment control module | 4 | |||
| → S1 | Exterior lamp switch | 14 | |||
| → 07/06 | |||||
| Z56/8 | Engine compartment connector sleeve, fanfare horns | ← N10/1 | Driver-side SAM control module with fuse and relay module | 3.2 | |
| → H2 | Left fanfare horn | 2 | |||
| → H2/1 | Right fanfare horn | 2 | |||
| 06/05 → | |||||
| Z108 | Washer nozzle heater connector sleeve | ← N10/1 | Driver-side SAM control module with fuse and relay module | 6.4 | |
| → R2/2 | Left heated windshield washer nozzle | 2 | |||
| → R2/3 | Right heated windshield washer nozzle | 2 | |||