Remove/install rear bumper - AR88.20-P-2200V
MODEL 171.4 except CODE (220) Parktronic system (PTS)
| Remove/install | |||
|---|---|---|---|
| 1 | Remove trim from rear end center assembly | AR68.30-P-4785V | |
| 2 | Unscrew bolts (2) on left and right side of vehicle | ||
| 3 | Remove expanding clips (3) | ||
| 4 | Open service flap (4) and unscrew bolts (5) | ||
| 5 | Unscrew nuts (6) | ||
| Gap between trunk lid and bumper | *BE60.00-P-1003-01L | ||
| 6 | Remove rear bumper (1) from vehicle with aid of helper | ||
| 7 | Install in the reverse order |
TEST AND ADJUSTMENT VALUES FOR GAP DIMENSIONS
| Number | Designation | Model 171 | |||
|---|---|---|---|---|---|
| BE60.00-P-1003-01L | Gap dimension | Trunk lid to rear fender | Dim. "F" | mm | 3.5 (+1.5) |
| Trunk lid to taillamp | Dim. "M" | mm | 4.0 (+1.6/-0.5) | ||
| Trunk lid to bumper | Dim. "V" | mm | 5.0 (+1.5/-1.0) | ||
| Rear fender to taillamp | Dim. "U" | mm | 2.5 (± 0.5) | ||
| Trunk lid tip to rear fender | Dim. "E" | mm | 5.0 (+1.5) | ||
| Fig., see | AR60.00-P-0700-01V | ||||