Remove/install paneling on A-pillar - AR68.30-P-4050V

MODEL 171.4 

Fig 1: Identifying Paneling On A-Pillar Components

Courtesy of MERCEDES-BENZ USA

	Remove/Install
1	Open Vario roof completely	See Operating Instructions
2	Remove left or right sun visor		AR68.60-P-5480V
3	Unscrew bolt from counter bearing (4) on sun visor
4	Lower A-pillar paneling (1) in area of overhead control panel control module (N70)
5.1	Disconnect electrical connector (2) from overhead control panel control module (N70)	Only on vehicles with code (876) Interior light package
6	Unclip A-pillar paneling (1) with mounting wedge	Position mounting wedge directly to clip (3).
		Installation:  Check clip (3), replace if necessary.	Figure
7	Remove A-pillar paneling (1) upward from instrument panel guide (arrow)	Installation:  Ensure that all gaskets are positioned properly in the entire area of the A-pillar paneling (1).
8.1	Remove counter bearing (4) from A-pillar paneling (1).	Only when replacing A-pillar paneling (1)
9.1	Remove left front make-up mirror lamp (E14/6) or right front make-up mirror lamp (E14/7) from A-pillar paneling (1) together with wiring harness (5).	Only when replacing A-pillar paneling (1) and only on vehicles with code (876) Interior light package.
10	Install in the reverse order

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA