Remove/install fender liner in front fender - AR88.10-P-1300R

MODEL 230.4 except CODE (P99) "AMG Black Series" special model 

Shown on vehicle up to 28.2.06, left fender liner 

Fig 1: Identifying Fender Liner In Front Fender Components - Model 230.4

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/install
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
1	Raise vehicle with vehicle lift
	Remove fender liner front section (1)
2	Unscrew bolts (3) and bolt (4)
3	Unscrew nuts (5).
4	Remove fender liner front section (1).	Installation:  Ensure that front section of fender liner (1), and rubber seal are seated properly.
	Fender liner rear section (2)
5	Remove front wheel
	Remove/install wheels, rotate if necessary		AP40.10-P-4050Z
6	Unscrew bolts (6) from rear engine compartment paneling (7).
7	Pull down rear engine compartment paneling (9) until nuts (8) are accessible and unscrew nuts (8).
8	Unscrew nuts (9).
9	Unscrew bolts (10) and bolt (4)
10	Remove expansion clips (11) from longitudinal member paneling
11	Remove fender liner rear section (2).	Installation:  Ensure that fender liner rear section (2) and rubber seal are seated properly.
12	Install in the reverse order

Fig 2: Identifying Adapter Kit (230 589 00 31 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.