Retrofit mount for Tablet PC - AZ82.80-P-0003-03CW

The following work procedure is shown on the right side of the vehicle. Installation on the left side of the vehicle is performed correspondingly.

1. Slide Tablet PC mount (3) onto previously installed bracket.
2. Connect black 3-pin coupling (6.2) of wiring harness (6) to Tablet PC mount (3).
3. Route wiring harness (6) into opening in the backrest.
4. Slide Tablet PC mount (3) further onto bracket until the lower edge of the Tablet PC mount (3) rests on the backrest.
5. Tighten Tablet PC mount (3) using the screws/bolts (19) included in the installation kit from the front onto the bracket.
   Fig 1: Identifying PC Mount Screws/Bolts, Wiring Harness & Connector

   Courtesy of MERCEDES-BENZ USA