Retrofit Tablet PC mount control unit - AZ82.80-P-0003-01SX

The following work procedure is shown on the right side of the vehicle. Installation on the left side of the vehicle is performed correspondingly.

1. Bond felt tape onto rear entertainment control unit (2).

   Do not bond the bottom of the rear entertainment control unit (2).

   Fig 1: Identifying Rear Entertainment Control Unit

   Courtesy of MERCEDES-BENZ USA
2. Glue rear entertainment control unit (2) using Velcro strip (21) onto cross strut (22).

   The bonding areas must be free of dust and grease. Otherwise there may be adhesion problems.

   Fig 2: Installing Rear Entertainment Control Unit

   Courtesy of MERCEDES-BENZ USA