Remove/install rear door lining - AR72.12-P-1010SXS

MODEL 221.1 with CODE (Z07) Top protection 

Fig 1: Identifying Rear Door Lining Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Notes on avoiding damage to windows installed in special high-security vehicles		AH67.00-P-0003-01FB
1	Switch off the ignition and remove the transmitter key from the EIS control unit
2	Remove concealed screws (arrows) below armrest on door lining (1) on left or right rear door		*BA72.12-P-1016-01N
3	Pry off door lining (1) at locking pins (4) on rear door	Insert long wedge immediately next to the locking pins (4) and unclip locking pins (4) individually. Ensure that the retaining pins (4) do not tear out of the door lining (1) and thereby damage the door lining (1).
			Figure
4	Detach door lining (1) from rear door until left rear door control unit (N69/3) or right rear door control unit (N69/4) is accessible	As soon as the door lining (1) is detached, ensure that the electrical wiring harness for the left rear door tweeter or right rear door tweeter is not under too much tension. Otherwise, the left rear door tweeter or right rear door tweeter can be damaged.
5	Disconnect electrical connectors (2, 3) from left rear door control unit (N69/3) or right rear door control unit (N69/4)
6	Unhook release cable from inside door opener
7	Disconnect electrical connector from left rear door tweeter or right rear door tweeter and remove door lining (1)
8	Install in the reverse order

REAR DOOR

Number	Designation		Model 221 with code Z07/ Z07+Z19
BA72.12-P-1016-01N	Bolt, door lining to inner door panel	Nm	8

Fig 2: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA