Location and assignment of Z connector sleeves (connectors and wiring harness) - trunk right - GF00.19-P-3000-07SAA
Model 221
| Z connector sleeve | Designation | Component | Designation | Connector. Pin |
|---|---|---|---|---|
| Z3/19 | Circuit 15 connector sleeve (fused) (PTS) | |||
| Up to 09/09 | ← N10/2 | Rear SAM control unit with fuse and relay module | 135 | |
| → N62/1 | Radar sensors control unit (SGR) | A.5 | ||
| → Z36/35 | Rear radar sensors sensor power supply connector sleeve | |||
| →Z36/27 | DISTRONIC front voltage supply connector sleeve | |||
| Z4/6(5) | Luggage compartment lamp circuit 30 connector sleeve | ← N10/2 | Rear SAM control unit with fuse and relay module | K4.26 |
| → E40/2 | Left trunk lid ambient and warning lamp | 2 | ||
| → E40/3 | Right trunk lid ambient and warning lamp | 2 | ||
| Z6/92 | Trunk lid ground connector sleeve | ← W54 | Ground (right rear wheelhouse) | |
| → E19/1 | Left license plate lamp | 2 | ||
| → E19/2 | Right license plate lamp | 2 | ||
| → E40/2 | Left trunk lid ambient and warning lamp | 1 | ||
| → E40/3 | Right trunk lid ambient and warning lamp | 1 | ||
| → M14/7 | Trunk lid CL [ZV] motor | 1.3 | ||
| up to 05/07 | → S62/21 | Trunk lid Keyless Go pushbutton | 1 | |
| → S88/6 | Trunk lid contact switch | 1 | ||
| → S88/8 | Trunk lid external operation switch | 1 | ||
| USA | → S88/10 | Trunk lid emergency release switch | 1 | |
| Z36/1z1 | Rear PTS sensor ground connector sleeve | |||
| ← N62 | PTS control unit | A.7 | ||
| As of 06/09 | → B8/7 | Outer right rear PTS ultrasonic sensor | 2 | |
| As of 06/09 | → B8/8 | Inner right rear PTS ultrasonic sensor | 2 | |
| As of 06/09 | → B8/9 | Inner left rear PTS ultrasonic sensor | 2 | |
| As of 06/09 | → B8/10 | Outer left rear PTS ultrasonic sensor | 2 | |
| Z36/2z1 | Rear PTS sensor voltage supply connector sleeve | |||
| ←N62 | PTS control unit | A.16 | ||
| As of 06/09 | → B8/7 | Outer right rear PTS ultrasonic sensor | 3 | |
| As of 06/09 | → B8/8 | Inner right rear PTS ultrasonic sensor | 3 | |
| As of 06/09 | → B8/9 | Inner left rear PTS ultrasonic sensor | 3 | |
| As of 06/09 | → B8/10 | Outer left rear PTS ultrasonic sensor | 3 | |
| Z36/17 | Rear CAN (low) sensor connector sleeve | |||
| Up to 05/09 | ← N62/1 | Radar sensors control unit (SGR) | A.15 | |
| As of 06/09 | ← Z37/7 | CAN bus (low) connector sleeve | ||
| Valid for Blind Spot Assist, up to 05/09 | → A86/2b1 | Right outer radar sensor, rear bumper | 5.3 | |
| Up to 05/09 | → A86/2b2 | Right inner radar sensor, rear bumper | 6.3 | |
| Up to 05/09 | → A86/2b3 | Left inner radar sensor, rear bumper | 7.3 | |
| Valid for Blind Spot Assist, up to 05/09 | → A86/2b4 | Left outer radar sensor, rear bumper | 8.3 | |
| As of 06/09 | → A86/2b1 | Right outer radar sensor, rear bumper | 3 | |
| As of 06/09 | → A86/2b4 | Left outer radar sensor, rear bumper | 3 | |
| Z36/19 | Rear CAN (high) sensor connector sleeve | |||
| Up to 05/09 | ← N62/1 | Radar sensors control unit (SGR) | A.14 | |
| As of 06/09 | ← Z37/6 | CAN databus (high) connector sleeve | Valid for Blind Spot Assist, up to 05/09 | |
| → A86/2b1 | Right outer radar sensor, rear bumper | 5.2 | ||
| Up to 05/09 | → A86/2b2 | Right inner radar sensor, rear bumper | 6.2 | |
| Up to 05/09 A86/2b3 | → Left | inner radar sensor, rear bumper | 7.2 | |
| Valid for Blind Spot Assist, up to 05/09 | → A86/2b4 | Left outer radar sensor, rear bumper | 8.2 | |
| As of 06/09 | → A86/2b1 | Right outer radar sensor, rear bumper | 2 | |
| As of 06/09 | → A86/2b4 | Left outer radar sensor, rear bumper | 2 | |
| Z36/35 | Rear PTS sensor voltage supply connector sleeve | ← Z3/19 | Circuit 15 connector sleeve (fused) (PTS) | |
| Valid for Blind Spot Assist, up to 05/09 | ←A86/2b1 | Right outer radar sensor, rear bumper | 5.4 | |
| Up to 05/09 | → A86/2b2 | Right inner radar sensor, rear bumper | 6.4 | |
| Up to 05/09 | → A86/2b3 | Left inner radar sensor, rear bumper | 7.4 | |
| Valid for Blind Spot Assist, up to 05/09 | → A86/2b4 | Left outer radar sensor, rear bumper | 8.4 | |
| As of 06/09 | → A86/2b1 | Right outer radar sensor, rear bumper | 4 | |
| As of 06/09 | → A86/2b4 | Left outer radar sensor, rear bumper | 4 | |
| Z36/36 | Rear PTS sensor ground connector sleeve | ← W17/1 | Ground (left rear seat) | |
| Valid for Blind Spot Assist, up to 05/09 | → A86/2b1 | Right outer radar sensor, rear bumper | 5.1 | |
| 5.5 | ||||
| 5.6 | ||||
| Up to 05/09 | → A86/2b2 | Right inner radar sensor, rear bumper | 6.1 | |
| 6.5 | ||||
| Up to 05/09 | → A86/2b3 | Left inner radar sensor, rear bumper | 7.1 | |
| 7.6 | ||||
| Valid for Blind Spot Assist, up to 05/09 | → A86/2b4 | Left outer radar sensor, rear bumper | 8.1 | |
| As of 06/09 | → A86/2b1 | Right outer radar sensor, rear bumper | 1 | |
| 5 | ||||
| 6 | ||||
| As of 06/09 | → A86/2b4 | Left outer radar sensor, rear bumper | 1 | |
| Z37/6 | CAN databus (high) connector sleeve | ← N62/1 | Radar sensors control unit (SGR) | A.14 |
| Taxi | → A49/5 | Radio data transmission two-way radio | 3.5 | |
| Taxi | → A50/2 | Credit card reader and printer | 1.5 | |
| Taxi | → A67 | Inside rearview mirror unit | 2.1 | |
| Taxi | → X1/44 | Taxi peripherals separation point | 1.5 | |
| → Z36/18 | Front CAN (high) sensor connector sleeve | |||
| → Z36/19 | Rear CAN (high) sensor connector sleeve | |||
| Z37/7 | CAN bus (low) connector sleeve | ← N62/1 | Radar sensors control unit (SGR) | A.15 |
| Taxi | → A49/5 | Radio data transmission two-way radio | 3.6 | |
| Taxi | → A50/2 | Credit card reader and printer | 1.6 | |
| Taxi | → A67 | Inside rearview mirror unit | 2.2 | |
| Taxi | → X1/44 | Taxi peripherals separation point | 1.6 | |
| → Z36/16 | Front CAN (low) sensor connector sleeve | |||
| → Z36/17 | Rear CAN (low) sensor connector sleeve |