Wiring diagram for ME-SFI [ME] gasoline injection and ignition system control unit - PE07.61-P-2101-99SAH
ENGINE 156 in MODEL 221.0 /1 control unit N3/10, vehicle side
| Code: | Designation: | Position: |
|---|---|---|
| A0 | Explanation of color codes | 40 L |
| B37 | Accelerator pedal sensor | 31 H |
| B4/15 | Fuel pressure sensor | 4 K |
| B4/3 | Fuel tank pressure sensor | 14 K |
| G3/3 | Left O2 sensor upstream TWC [KAT] | 11 K |
| G3/4 | Right O2 sensor upstream TWC [KAT] | 9 K |
| G3/5 | Left O2 sensor downstream TWC [KAT] | 7 K |
| G3/6 | Right O2 sensor downstream TWC [KAT] | 6 K |
| K17 | AIR relay module | 26 K |
| M4/7 | Electric suction fan engine and AC with integrated control | 25 H |
| N10/1 | Front SAM control module with fuse and relay module | 17 L |
| N118 | Fuel pump control module | 28 H |
| N2/7 | Restraint systems control module | 21 L |
| N3/10 | ME-SFI [ME] control module | 4 A |
| N3/10 | ME-SFI [ME] control module | 12 A |
| N3/10 | ME-SFI [ME] control module | 20 A |
| N3/10 | ME-SFI [ME] control module | 30 A |
| U1 | Valid for {{USA}} | 13 A |
| U12 | Valid for left-hand steering | 22 C |
| U13 | Valid for right-hand steering | 22 D |
| W15/1 | Ground (right footwell) | 22 F |
| W18 | Ground (left front seat crossmember) | 33 H |
| W34/1 | Ground (electronics - left footwell) | 22 E |
| X30/21 | Drive train CAN voltage distributor connector | 32 L |
| X30/30 | Chassis CAN/FFS [RBA] voltage distributor connector | 29 L |
| Y110 | Three-disk thermostat valve | 1 L |
| Y16/2 | Heating system shutoff valve | 2 L |
| Y58/1 | Purge control valve | 13 K |
| Y58/4 | Activated charcoal filter shutoff valve | 14 K |
| Z5 | Connector sleeve (solder joint in harness) | 7 E |
| Z7/36 | Circuit 87M2e connector sleeve | 2 H |
| Z7/5 | Circuit 87 connector sleeve | 17 H |
| Z7/5 | Circuit 87 connector sleeve | 18 E |