Prepare bottom rear center section for installation - AR64.20-P-1000-07SX

Fig 1: Identifying Bottom Rear Center Section Mating Surfaces (1 Of 2)

Courtesy of MERCEDES-BENZ USA

1. Grind mating surfaces on bottom rear center section (1) down to bare metal in cross-hatched areas with round wire brush consisting of stainless steel (areas A, B, C, D, E, F, G, H, I, J, K and L).

Observe preliminary treatment of surfaces to be bonded.

2. Grind mating surfaces on mount below taillamp (2) down to bare metal in cross-hatched areas with round wire brush consisting of stainless steel (areas M, N, O, P, Q, R, S, T, U, V, W, X, Y and Z).

Observe preliminary treatment of surfaces to be bonded.

Observe preliminary treatment of surfaces to be bonded.

Fig 2: Identifying Bottom Rear Center Section Mating Surfaces (2 Of 2)

Courtesy of MERCEDES-BENZ USA