Remove/install door sill molding - AR68.30-P-4100RT

MODEL 251 

Fig 1: Identifying Door Sill Molding Remove/Install Component (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Door Sill Molding Remove/Install Component (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove/Install
1	Completely open front and rear door
2	Unclip front door sill molding (1) and rear door sill molding (3) upward from retaining clips (arrows) by hand and remove.	Replace damaged retaining clips. Ensure that guide lugs are seated correctly on front door sill molding (1) or rear door sill molding (3) in mounts (2, 4). Ensure that the rear section of the rear door sill molding (3) runs below the edge guard (5)
3	Install in the reverse order