Remove/install rear dome lamp - AR82.20-P-0113RT

MODEL 251 

Fig 1: Identifying Rear Dome Lamp Remove/Install Components - Shown On Code 220

Courtesy of MERCEDES-BENZ USA

Shown on vehicles with Parktronic system (PTS), code 220 

	Remove/Install
1	Switch off ignition and remove the transmitter key from the EIS [EZS] control unit	On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until the ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m).
2.1	Unclip rear dome lamp PTS warning indicator (A44/3) towards right (arrow A) and then lower to remove (arrow B)	Only for vehicles with Parktronic system (PTS), code 220. Treat ribbon cable carefully to prevent damage.
3.1	Disconnect electrical connector (1) of the rear dome lamp PTS warning indicator (A44/3)	Only for vehicles with Parktronic system (PTS), code 220.
4	Carefully unclip left dome lamp, 3rd seat row (E15/3) at the clips (2) and remove	Treat ribbon cable carefully to prevent damage.
		Long wedge	Fig 2
5	Disconnect electrical connector (3) of the left dome lamp, 3rd seat row (E15/3)
6	Install in the reverse order

Fig 2: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA