Remove/install paneling on B-pillar - AR68.30-P-4700GZ

MODEL 164

Shown on model 164.1, front seat removed for better illustration

Fig 1: Identifying Paneling Remove/Install Components On B-Pillar - Shown On Model 164.1

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/install
1	Remove door sill molding		AR68.30-P-4100GZ
2	Loosen seat belt on front seat at bottom		*BA91.40-P-1008-01H
3	Unclip cover (1)	Long wedge	Figure
4	Remove screw (2)
5	Unclip B-pillar paneling (3) at top.	In marked areas (arrows).
		Mounting wedge	Figure
6	Thread seat belt and remove upper B-pillar paneling (3).
7	Unclip lower B-pillar paneling (4).	In marked areas (arrows).
		Long wedge	Figure
8	Install in the reverse order

SEAT BELTS/EMERGENCY TENSIONING RETRACTORS

Number	Designation		Models 164.1/8
BA91.40-P-1008-01H	Bolt, seat belt fitting to front seat	Nm	35

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 3: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.