Remove/install rear dome lamp - AR82.20-P-0113GZ

MODEL 164 

Shown on model 164.1, with Parktronic system (PTS), code 220 

Fig 1: Identifying Rear PTS Warning Indicator Dome Lamp

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/install
1	Switch off ignition and remove the transmitter key from the EIS [EZS] control unit	On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m).
2.1	Unclip rear dome lamp PTS warning indicator (A44/3) by moving to right (arrow A) and then remove by lowering (arrow B)	Only for vehicles with Parktronic system (PTS), code 220. Treat ribbon cable carefully to prevent damage.
3.1	Disconnect electrical connector (1) of the rear dome lamp PTS warning indicator (A44/3)	Only for vehicles with Parktronic system (PTS), code 220.
4	Carefully unclip left dome lamp, 3rd seat row (E15/3) at the clips (2) and remove	Treat ribbon cable carefully to prevent damage.
		Long wedge	Figure
5	Disconnect electrical connector (3) of the left dome lamp, 3rd seat row (E15/3)
6	Install in the reverse order

Fig 2: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.