Installing and connecting sensors - AZ54.65-P-0001-03T

Clip sensor holder (10) into ram strip (13).

Fig 1: View Of Sensor Holder In Ram Strip
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Clip sensors (12) into sensor holder (10) so that the connecting coupling (arrow) is inside pointing to the center of the ram strip.
The right-hand sensors with the coupling pointing to the left and the left hand sensors with the coupling pointing to the right.

Fig 2: Pointing Connecting Coupling
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Install ram strip in bumper and connect bumper wiring harness (1) to sensors (12).
The connecting coupling with the grommet must be on the left-hand side of the bumper.
Hook the wiring harness (1) into the holder provided on the bumper.

Fig 3: Identifying Wiring Harness And Sensors
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Attach the supplied retaining clips (14) in the bumper and fasten the wiring harness (1).

Fig 4: Identifying Retaining Clips
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.