Pressing rubber mount with grooved ball bearing onto joint fork - AR41.10-P-0100-05DA

Fig 1: Identifying Drift (126 589 03 15 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Drift (201 589 07 15 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

The open side of the grooved ball bearing must point backwards.

1. Press rubber mount (7) with grooved ball bearing onto linkage arm using drift (05).

   126 589 03 15 00 use with grooved ball bearing dia. of 32 mm.

   201 589 07 15 00 use with grooved ball bearing dia. of 27 mm.

   Fig 3: Pressing Rubber Mount With Grooved Ball Bearing Onto Linkage Arm

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.