Pressing grooved ball bearing out and in at rubber mount of propeller shaft - AR41.10-P-0100-02DA

Fig 1: Identifying Removal And Installation Tool (116 589 09 43 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Removal And Installation Tool (201 589 09 43 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Press out grooved ball bearing 

1. Using the press out/in (tool 04), pry the grooved ball bearing (8) out of the rubber mount (7).

   116 589 09 43 00 use with grooved ball bearing inside dia. of 30 mm.

   201 589 09 43 00 use with grooved ball bearing inside dia. of 25 mm.

   Fig 3: Prying Grooved Ball Bearing Out Of Rubber Mount

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

   Press in grooved ball bearing 

2. Press grooved ball bearing (8) into the rubberized bearing seat up to the contact surface (arrows) using removal tool and press-in tool (04).

Ensure that the grooved ball bearing (8) is properly seated.

Fig 4: Pressing In Grooved Ball Bearing

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.