Connect sections of propeller shaft - AR41.10-P-0050-05DA

Long-life grease (NLGI grade 2)

BB00.40-P-0266-02A

1. Coat the splined profile with Molykote grease before assembly.
2. Reconnect front and rear sections of propeller shaft. The humps on the front propeller shaft must be between the two humps on the linkage arm (arrows).

Ensure correct seat of rubber sleeve at large diameter.

Position of propeller shaft without clamp connection 

Fig 1: Locating Humps On Linkage Arm

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Position of propeller shaft with clamp connection 

Fig 2: Positioning Propeller Shaft

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.