Processing permanent underbody protection agent for painting - AR97.20-P-0500-03A

Permanent underbody protection agent (synthetic rubber), dark gray 

The permanent underbody protection agent is designed on a synthetic rubber basis and is suited for processing fender bottom sections, underbody as well as transitions to original standard PVC underbody protection.

Not suited for sealing work (seam sealing). Blow through spray gun with solvent after use. Ensure that air hole on screw-in thread is free.

Permanent underbody protection (water-base dispersion), gray 

This permanent underbody protection agent is a water-base dispersion suitable for use on the underbody, fender bottom sections as well as outer surface For processing on the outer surface (e.g. front fender below bumper, longitudinal members at entry) thin material with 5 % water to achieve better coverage.

This underbody protection agent is not suited for the transitions to the original standard PVC underbody protection agent and to the sealing work (seam sealing) because it can result in insufficient adhesion and crack formation

After finishing work, clean equipment thoroughly with water and moisten air flap with mineral oil before reusing, otherwise the spray mist can dry affecting the function

Processing permanent underbody protection agent for painting 

• All areas to which permanent underbody protection agent is to be applied must be thoroughly cleaned (steam cleaner). In particular, remove wax and oil residues as well as loose pieces of PVC thoroughly. Grind corroded points down to bare metal and prime.

A hot air gun and flat nozzle with integrated scraper or rotating wire brushes are suitable for removing the PVC material.

• Apply permanent underbody protection agent uniformly with spray gun.

Do not spray permanent underfloor protection on equipment, otherwise, the function could be impaired.

• Observe drying time before overpainting.