Notes on sprayable joint sealant - AH97.10-P-0002-01A

All models 

Application areas: 

With this material, when applied over large surfaces on areas such as the wheelhouses, longitudinal members (rocker panels) and vehicle floor elements, the characteristics are visually equivalent to the standard or plant seals in terms of the processing.

When applying the material from the standard cartridge (300 ml), a special compressed air gun is required which allows different types of application for structured joints, surface coatings, stone-impact protection and sound deadening in combination with the associated plastic injection nozzles.

Processing: 

• Wet-in-wet painting possible between 30 min. and 8 h after application without paint additives. Forced drying is necessary between 8 h and 72 h. Longer standing times should be avoided to exclude paint adhesion losses.
• Adhesion surfaces must be clean, dry and free of grease.
• Spray filler/filler primer before application of sprayable joint sealing agent.
• Never apply the sprayable joint sealing agent to fresh (unhardened) 1K polyurethane material.

Specific material advantages of "sprayable joint sealing agent": 

• Does not contain any isocyanates, silicone, PVCs and no dangerous agent.
• The replaceable nozzle makes cleaning unnecessary.
• Visual repair of the plant seals and underbody coating.
• Good stability.
• UV-resistant.
• Material offers a number of application possibilities.
• With the proper gun setting, the sprayable joint seal can be applied as joint seal and surface coating in sequence.
• It is necessary, however, to wait for the end of the skin formation period of about 15 min. for the sprayed seam.
• Can be painted over well.