LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2009 >> E550 Base >> Repair and Diagnosis >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Sliding Roof, Soft Top -- E550 (211.072) >> Testing & Repair >> Install panoramic roof frame - AR77.21-P-0800-04T

Install panoramic roof frame - AR77.21-P-0800-04T

TEST AND ADJUSTMENT VALUES OF PANORAMIC ROOF

Number Designation     Model 211.0
BE77.21-P-1001-01A Size of gap Height adjustment of wind deflector to front glass roof mm 1 (±1)
    Height adjustment of front glass roof to rear glass roof mm 1 (±1)
    Height adjustment of rear glass roof to rear window mm 5 (±1)
    Wind deflector to front glass roof mm 1 (±1)
    Rear glass roof to rear window mm 5 (±1)
Fig 1: Identifying Feeler Gauge (129 589 03 21 00)
G07508805Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Fig 2: Identifying Spacer Blocks (211 589 03 23 00)
G07508806Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
WORKSHOP EQUIPMENT

WE58.40-Z-1029-11A Cup suction tool for window removal and installation
  1. Lift panoramic roof frame over roof opening with the aid of four helpers and lower slowly.
  1. 2.1 Connect electrical connectors for solar module in rear area at bottom of panoramic roof frame.

    IMPORTANT On vehicles up to 31.5.06 and code (413) Panoramic sliding roof with code (419) Solar module for panoramic glass roof.

  2. 3.1 Connect electrical connectors for roof antenna in rear area at bottom of panoramic roof frame.

    IMPORTANT On vehicles as of 1.6.06 and code (494) USA version. Depending on the equipment, the electrical connector on the roof antenna can be located on the left or right side of the vehicle or on both sides of the vehicle. If a dummy antenna is installed instead of the roof antenna, the electrical connector is not required.

  3. 4 Install panoramic roof frame on adhesive bead.
  4. 5 SPECIAL TOOL Insert spacer blocks into roof carrier mounts and align panoramic roof frame to side roof paneling.
  5. 6 Align gap between glass roof and rear window with COMMERCIALLY AVAILABLE TOOLS feeler gauge.
  6. 7 Press on panoramic roof frame all the way around.
  7. 8 Check height adjustment of rear glass roof to heated rear window, if necessary press again against rear panoramic roof frame.
  8. 9 Check transition to windshield, if necessary press front panoramic roof frame again.

    NOTES Check transition to windshield, otherwise it is not possible to install the windshield molding.

  9. 10 COMMERCIALLY AVAILABLE TOOLS Remove cup suction tool.
scientia non olet · About LEMON Manuals