Notes on cavity preservation - AH97.20-P-0001-01C

Prepare preservation surfaces 

Always clean surfaces and hollow cavities to be preserved.

Surfaces and hollow cavities must be dry before application.

Spray probe 

The spray probe must be "stiff". Spray probes that tend to roll up are not suitable.

Processing notes 

The optimum application temperature is 20-35°C. It should not be less than +15 °C

Before starting application, check spray pattern. The preservation agent should spray uniformly out of the openings in the shape of a cone.

Optimum application can be achieved by slowly retracting/extending and simultaneously turning the spray probe during application.

Always apply two coats one after another with an air drying time of 5 min. in between.

Always cover brake disks, brake linings, belt drive and propeller shaft to prevent brake failure or propeller shaft imbalance.

Always cover exhaust, otherwise the preservation agent could catch fire or emit unpleasant odors.

Avoid preservation mist in vehicle interior to prevent damage to interior equipment.

Avoid preservation mist on inner side of bumper to prevent bumper deformation.

Clean tools after application.

After drying preservation, ensure that all drain holes are free.