Inside door handle and footwell illumination, function - GF82.20-P-2024T

MODELS 211.0 /2 /6 

The actuation of the footwell illumination and the door inside handle illumination depends on the overhead control panel control unit (N70).

The following lamps are actuated for the entrance/exit illumination:

• left front door inside handle illumination (E17/11)
• right front door inside handle illumination (E17/12)
• Left rear door inside handle illumination (E17/13)
• right rear door inside handle illumination (E17/14)
• Right front footwell lamp (E17/15)
• Left front footwell lamp (E17/16)
• Right rear footwell lamp (E17/17)
• Left rear footwell lamp (E17/18)

The door inside handle illumination continues to be actuated as ambient illumination at a reduced output of 15 to 100 % in t = 1 s as a function of the rain/light sensor (B38/2) via the overhead control panel control unit (N70) and the door control units.

After the CAN message from the overhead control panel control unit (N70), the footwell illumination is switched off after a switch-on time of 10 minutes via the driver-side SAM control unit with fuse and relay module (N10/1).

In Model 211.6, depending on equipment and special body, the number and position of the interior lamps may vary.