Retrofit rear entertainment screen - AZ82.60-P-0015-03TA

The following operation steps are shown on the right side of the vehicle and can be accomplished analogously on the left side of the vehicle.

1. Slide screen (3) onto bracket.
2. Create electrical connection between screen (3) and wiring harness (6).
3. Route electrical connector in opening of backrest.
4. Slide screen (3) onto bracket until lower edge of screen (3) makes contact with backrest.
5. Tighten screen (3) at bracket from front using screws/bolts (19) contained in installation kit.
   Fig 1: Identifying Rear Entertainment Screen, Wiring Harness & Screws/Bolts

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.