Removing left locking ring from rear axle housing using spreader - AR35.31-P-0550-01T
TEST VALUES FOR FRICTION TORQUE OF REAR AXLE DIFFERENTIAL
| Number | Designation | Model 171.456 | Model 211.006/054/056/065/082/087/092/206/254/256/265/282/287/292/606, Model 211.004 with code 450 | |
|---|---|---|---|---|
| BE35.31-P-1001-04F | Rear axle housing expansion (spread dimension) for circlip removal | mm | 0.10...0.13 | 0.10...0.13 |
TEST VALUES FOR FRICTION TORQUE OF REAR AXLE DIFFERENTIAL
| Number | Designation | Model 219.356 | Model 230.467 | |
|---|---|---|---|---|
| BE35.31-P-1001-04F | Rear axle housing expansion (spread dimension) for circlip removal | mm | 0.10...0.13 | 0.10...0.13 |
- Attach spreader (058) to the rear axle housing; to do this, tighten collar bolts (arrows) (guidance value: approx. 50 Nm).
- Position measuring yoke (059) for expansion dimension measurement on spreader (058) and press against the two bolts from below.
Set dial gauge to "0" with 3 mm preload.
The stop pin (arrow) on the contact arm must touch the contact surface on the rear axle housing.
- Turn the even surface (arrow) of the thrust piece to the opening of the locking ring (29).
- Screw in the threaded spindle (058a) of the spreader (058) by hand until the thrust piece abuts the tapered roller bearing outer race.
- Screw in the threaded spindle (058a) of the spreader (058) until the rear axle housing has reached a spread dimension of 0.10 to 0.13 mm.
Do not exceed the spread dimension when spreading. Otherwise the rear axle housing may become damaged.
- Remove contact arm (059).
- Remove left circlip (29) from rear axle housing using pliers (064)
- Mark the left circlip (29).
- Unclamp the rear axle housing and detach spreader (058).