Stationary heater switch task - GF83.70-P-4056-02T

Using the stationary heater switch (N72s12) the operation of the stationary heater in the vehicle can be triggered manually immediately or irrespective of the preceding type of triggering, and can be interrupted manually or by preprogramming. The stationary heater switch (N72s12) has 3 function LEDs:

• a red LED for the display of the heating function,
• a blue LED for displaying the ventilation function and
• a yellow LED for displaying the activated preselection time.

The red and the blue LED illuminate in the same position (front position, fiber optics). The display of preselection time lights up at the rear LED position of the stationary heater switch (N72s12). When the stationary heater switch (N72s12) is pressed the message "Operate stationary heater/ventilation" is sent.