Connect sections of propeller shaft - AR41.10-P-0050-05DA

AR41.10-P-0050-05DA	Connect sections of propeller shaft
	Long-life grease (NLGI grade 2)	BB00.40-P-0266-02A

1. Coat the splined profile with Molykote grease before assembly.
2. Reconnect front and rear sections of propeller shaft. The humps on the front propeller shaft must be between the two humps on the linkage arm (arrows).

   Ensure correct seat of rubber sleeve at large diameter.

   Position of propeller shaft without clamp connection 

   Fig 1: Locating Humps On Linkage Arm

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Position of propeller shaft with clamp connection 

Fig 2: Position Of Propeller Shaft With Clamp Connection

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.