Constant map matching, function - GF82.61-P-2002TU

MODEL 211.0/2 up to 30.6.06 with CODE (528) HIGH Class USA

Fig 1: View Of Basic Location Finding

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Map-Supported Location Finding

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 3: View Of GPS Map Matching

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Shown on Model 211.0

With code (527) navigation module for COMAND and code (528) HIGH Class USA the external navigation module is designated navigation processor (N41/1).

Continuous position finding is the calculation of the current vehicle position.

Even by opening the driver's door or with "circuit 15 ON" this is activated and carried out by the navigation processor (N41/1). During the switch-on phase (software is loaded), only basic map matching is available.

After "circuit 15 OFF" all the important location finding parameters are stored during a run-on time of 30 minutes.

Three complementary methods are utilized for continuous position finding. This ensures very accurate and reliable position finding.

These methods are:

Basic location finding
Map-supported map matching
GPS location finding

When entering the vehicle location there is the possibility of entering the location manually on the COMAND operating, display and control unit (A40/3). This may be useful after the vehicle has been transported (e.g. ferry or train) if there was no GPS reception at the start of the journey.

Basic location finding, function

GF82.61-P-3006TU