Install amplifier - AZ82.62-P-0002-01TA

Model 211.2 

1. Install carrier plate (21) with AMG amplifier unit (1).

   If necessary, existing control units are to be transferred from vehicle's own carrier plate to carrier plate (21) with AMG amplifier unit (1).

   Fig 1: Installing Carrier Plate With AMG Amplifier Unit

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
2. Route signal connecting cable (7).

   Signal connecting cable (7) is led to the left out of implement carrier (21) and routed along vehicle's own wiring harnesses to audio gateway (AGW) (up to code (808) Model year 2008) or amplifier for sound system (as of code (809) Model year 2009) and fixed in place with adhesive pads (included in package contents).

   Fig 2: Routing Signal Connecting Cable

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
3. Connect signal connecting cable (7).
4. Connect branch-off line of signal connecting cable (7) to connector of subwoofer booster amplifier.

   Disconnect and remove existing subwoofer booster amplifier on implement carrier (part is no longer required). Connector plug for subwoofer booster amplifier at branch-off line (13) of signal connecting cable (7).

   Up to code (808) Model year 2008 NTG 1; vehicle's own connectors are removed from AGW and inserted in jacks of signal connecting cable (7). Connectors of signal connecting cable (7) are then connected to AGW.

   As of code (809) Model year 2009 NTG 2.5; vehicle's own connectors are removed from amplifier for sound system (N40/3) and inserted in adapter box (20) of signal connecting cable (7). Connectors of signal connecting cable (7) are then connected to amplifier for sound system (N40/3) (see picture 3).

   The connectors are coded and cannot be interchanged.

5. Route voltage connecting cable (8) from installation location of AMG amplifier unit (1) to battery (G1).

   Voltage connecting cable (8) is routed below paneling at side in trunk on the right and fixed in place with adhesive pads (included in package contents).

6. Connect voltage connecting cable (8) to terminals.

   Connect brown line to terminal of negative terminal and red line to terminal of positive terminal.

   Fig 3: Routing Voltage Connecting Cable From Installation Location Of AMG Amplifier Unit To Battery (G1)

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
7. Fuse holder (9) of voltage connecting cable (8) is fixed in place with a cable tie (10) (included in package contents) at battery wiring harness.
   Fig 4: Identifying Fuse Holder, Voltage Connecting Cable And Cable Tie

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.