Wiper motor, function - GF82.30-P-4104-01T

Function 

In the reversing wiper used (reversing wiper system) a wiper motor (M6/1) with integral electronics (control logic and power semiconductors) is used which is controlled continuously. The speed requirement is effected via the serial interface from the driver-side SAM control module with fuse and relay module (N10/1).

This means that in the event of a previously actuated wipe cycle the wiper movement is moved back to its rest position by the reversing wiper itself.

Signals on the operating condition of the wiper motor (M6/1) are determined via an integral Hall sensor and passed on to the driver-side SAM control module with fuse and relay module (N10/1).