Connect wiring harness - AZ82.20-P-0001-02T

Connection diagram for wiring harness, illuminated door sill molding (4x) as shown on model 211.0 

Fig 1: Wiring Harness Connection Diagram

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

1. Connect wiring harness (6) with connection coupling to plug position 27 at rear SAM control unit with fuse and relay module (N10/2).
2. Put relay (7) onto plug position C and assign fuse (8) on fuse location 5 with a 7.5 A fuse.
   Fig 2: Identifying Relay, Fuse, Wiring Harness And SAM Control Unit With Fuse And Relay Module

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
3. Route wiring harness (6) in trunk along existing leads as shown in figure.
4. Connect brown ground lead to ground connection (arrow).
   Fig 3: Routing Wiring Harness In Trunk

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
5. Route branch-off line from wiring harness (6) for the illuminated door sill moldings in the cable duct under the left and right rear door (only with 4 door sill moldings).
6. Attach inverter (3) and route in cable duct.
   Fig 4: Identifying Inverter And Wiring Harness

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
7. Route branch-off line for illuminated door sill molding in cable duct at driver's door, right and left.
8. Attach inverter (3) and route in cable duct.
   Fig 5: Identifying Inverter

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
9. Put on relevant door sill at every affected door and drill and varnish 6 mm diam. hole (arrow) in weatherstrip fold of sill, level with relevant line terminator.

   Make hole as far onto lower weatherstrip fold as possible.

   Fig 6: Locating Hole In Weatherstrip Fold Of Sill

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
10. Clip illuminate door sill molding on and route connecting wire (11) through drilled hole.
11. Insert 2 pins of connecting wire (11) into a connector housing (4) and attach to wiring harness (6).
    Fig 7: Identifying 2 Pins Of Connecting Wire, Connector Housing And Wiring Harness

    Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
12. Connect the two-color door contact wire to branch-off line of same color in wiring harness (6) using provided clamping connector at each of the doors concerned.
    Fig 8: Identifying Door Contact Switch And Wiring Harness

    Courtesy of MERCEDES-BENZ OF NORTH AMERICA.