Remove/install left front SAM control unit with fuse and relay box - AR54.21-P-1260TX
MODEL 219.3 up to 31.5.06
| Remove/install | |||
| Notes on avoiding damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1.1 | Temporarily store basic data from driver-side SAM control unit with fuse and relay module (N10/1) in STAR DIAGNOSIS | When replacing driver-side SAM control unit with fuse and relay module (N10/1). |
|
| Connect STAR DIAGNOSIS and read out fault memory | AD00.00-P-2000-04TX | ||
| STAR DIAGNOSIS, diagnosis system | *WH58.30-Z-1048-13A | ||
| 2 | Disconnect battery ground cable | AR54.10-P-0003TX | |
| 3 | Open engine hood and move to vertical position | AR88.40-P-1000TX | |
| 4 | Release lever (1) in direction of arrow and remove cover (2) from fuse and relay box (3) | ||
| 5 | Separate electrical connectors (4) | ||
| 6 | Detach electrical line (5) from driver-side SAM control unit with fuse and relay module (N10/1) | ||
| 7 | Remove bolts (6) | ||
| 8 | Remove driver-side SAM control unit with fuse and relay module (N10/1) from the fuse and relay box (3) until the electrical connectors on the bottom side of the driver-side SAM control unit with fuse and relay module (N10/1) are accessible | ||
| 9 | Unplug all electrical connectors from driver-side SAM control unit with fuse and relay module (N10/1). | ||
| 10 | Unclip cutoff relay for interruptible loads (K75) together with bracket from driver-side SAM control unit with fuse and relay module (N10/1) | ||
| 11 | Remove driver-side SAM control unit with fuse and relay module (N10/1) | ||
| 12 | Install in the reverse order |
COMMERCIALLY AVAILABLE TOOLS
| Number | Designation | |
|---|---|---|
| WH58.30-Z-1048-13A | STAR DIAGNOSIS, diagnosis system; Compact Passenger Car | 6511 1801 00 |