Remove contacts from sensor laminated contact connector - AR00.19-P-0120-01A

WARNING: This page is about a different car, the 2009 Mercedes-Benz E550 and 2008 Mercedes-Benz E550. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying New Passenger Vehicle Wiring Harness Repair Kit (220 589 04 99 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Wiring Harness Repair Kit, Basic (000 589 13 99 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 3: Identifying Blade Holder With Clamping Pliers (220 589 01 99 50)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 4: Identifying SLK 2.8 - 97 Blade (220 589 01 99 63)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Unpin contact pins from the connector

Insert blade holder with clamping pliers and SLK 2.8 - 97 blade from front side into contact cavity of connector housing (4).
Both spring shackles on the contact pin (7) are pressed together and, simultaneously, the locking tab (5) of the connector housing (4) is lifted.

Fig 5: Inserting Blade Holder Clamping Pliers And Blade From Front Side Into Contact Cavity Of Connector Housing
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
A slight tug on the corresponding cable will remove the contact pin (7) from the connector housing (4).
Rocking the contact pin back and forth, thus making use of the full housing tolerance, may help to unpin the contact.