Remove/install spring control arm rubber mount - AR35.20-P-0114-01SX
- 1.1 Remove left rear muffler
When replacing the left rubber mount in the rear axle carrier.
- 1.2 Remove exhaust starting from the flange connection.
Pressing-out and pressing-in process of rubber mount
To move out the piston, screw in the pressure screw (010k) of the press (010h) until the piston is fully extended.
This process must be repeated approx. 5 times due to the short stroke of the press (010h)
To do this the piston is to be moved back by turning back the pressure screw (010k) and simultaneously tightening the hand wheel (068e). The spindle of the hand wheel (068e) must always exert a little pressure onto the press (01 0h) so that the tools cannot fall out.
Press out
- 2 Remove sleeve (068b) on bracket (068a).
- 3
Press out/in tool with thrust piece (068c) and Position press (01 0h) on rear axle carrier (1).
- 4 Secure press (01 0h) and thrust piece (068c) by tightening hand wheel (068e). In the process observe the chamfer (arrow) on sleeve (068b), it must abut the rear axle carrier (1) exactly.
- 5 Press out rubber bushing
Pressing in
- 6 Replace sleeve (068b) by sleeve (068f).
- 7 Insert rubber mount in bore of rear axle carrier (1).
- 8
- 9 Secure press (01 0h) and thrust piece (068g) by tightening hand wheel (068e). In the process observe the chamfer (arrow) on the sleeve, it must abut the rear axle carrier exactly.1
- 10 Press the rubber mount into the rear axle carrier (1) until the thrust piece (068g) abuts the rear axle carrier (1) (arrow).