Remove/install pressure sensor throttle valve actuator - AR07.04-P-0101H
ENGINE 275 in MODEL 215, 216, 220, 221, 230 Pressure sensor upstream of throttle valve actuator
ENGINE 285 in MODEL 240 Pressure sensor upstream of throttle valve actuator
Illustrated on model 240
Fig 1: Identifying Pressure Sensor Throttle Valve Actuator, Electrical Connector, Pneumatic Hose And Bolts
| Remove/install | |||
| Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof. | Keep body parts and limbs well clear of moving parts. | AS00.00-Z-0011-01A | |
| 1 | Remove engine trim panel | Engine 275.95, 285 | AR01.10-P-2405LA |
| Engine 275.98 | AR01.10-P-2405IM | ||
| 2 | Disconnect electrical connector (1) | ||
| 3 | Unscrew bolts (3) and take out pressure sensor upstream throttle valve actuator (B28/6) toward top | *BA07.04-P-1002-01C | |
| 4 | Remove pneumatic hose (2) on pressure sensor upstream of throttle valve actuator (B28/6) | ||
| 5 | Install in the reverse order |
SENSORS
| Number | Designation | Engine 275, 285 | |
|---|---|---|---|
| BA07.04-P-1002-01C | Bolt, pressure sensor in front of throttle valve actuator to bracket | Nm | 8 |