Correcting center articulation angle at propeller shaft intermediate bearing - AR41.10-P-0086-04T
PROPELLER SHAFT INTERMEDIATE BEARING
| Number | Designation | Model 211 | ||
|---|---|---|---|---|
| BA41.40-P-1001-01A | Bolt, propeller shaft intermediate bearing to frame floor assembly | Self-tapping screw | Nm | 25 |
| Bolt with washer | Nm | - | ||
| Bolt with collar and self-centering tip | Nm | - | ||
| Bolt with collar and without self-centering tip | Nm | - | ||
PROPELLER SHAFT INTERMEDIATE BEARING
| Number | Designation | Model 219 | ||
|---|---|---|---|---|
| BA41.40-P-1001-01B | Bolt, propeller shaft intermediate bearing to frame floor assembly | Self-tapping screw | Nm | 25 |
PROPELLER SHAFT INTERMEDIATE BEARING
| Number | Designation | Model 216 | Model 221 | ||
|---|---|---|---|---|---|
| BA41.40-P-1001-01E | Bolt, propeller shaft intermediate bearing to frame floor assembly | Self-tapping screw | Nm | 25 | 25 |
| Bolt with washer | Nm | - | 30 | ||
CROSSMEMBER AND FRONT REINFORCEMENT
| Number | Designation | Model 211 | |
|---|---|---|---|
| BA62.30-P-1001-01A | Bolt, crossmember to body | Nm | 25 |
CROSSMEMBER AND FRONT REINFORCEMENT
| Number | Designation | Model 219 | |
|---|---|---|---|
| BA62.30-P-1001-01C | Bolt, crossmember to body | Nm | 25 |
CROSSMEMBER AND FRONT REINFORCEMENT
| Number | Designation | Model 216 | Model 221 | |
|---|---|---|---|---|
| BA62.30-P-1001-01F | Bolt, cross member to transmission tunnel | Nm | 25 | 25 |
Correct articulation angle in the center (∠2)
To correct the inclination angle, install the shop-made shims at the propeller shaft center support bearing. A 1 mm thick shim changes the inclination angle by approx. 0.17°.
When using shims > 2 mm thick, increase the bolt length by 5 mm.
If a shim > 5 mm thick is required, check the front engine mount and rear engine mount for signs of settling or wear and replace if necessary.
- Detach crossmember (31).
Shows on model 211
- Detach split heat shield (105c) (arrows).
Shows on model 211
- Unscrew bolts (7a) from propeller shaft intermediate bearing.
- Insert shop-made shims between frame floor assembly and propeller shaft center support bearing (arrows).
The dimension for the shims must be taken from the propeller shaft center support bearing, see following picture.
- Screw in bolts (7a) for propeller shaft center support bearing
.
- Attach split heat shield (105c).
- Install cross member (31)
Shows on model 211
Example:
Shims (c) between frame floor and propeller shaft center support bearing.
Material: steel or aluminum