Remove/install front door lining - AR72.10-P-1000SC

MODEL 216.3 

Fig 1: Identifying Front Door Lining Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Wind crank window fully down
2	Remove cover (9)
3	Unclip mirror triangle cover (2) and lay down to side with electrical line connected.		*115589035900
4	Unclip door control unit cover (3) from door lining (1).		*115589035900
5	Disconnect electrical connectors (4) from left door control unit (N69/1) or right door control unit (N69/2)
6	Unscrew bolt (5).
7	Press door lining (1) on mounting clips (6) off of inner door panel.	Move assembly wedge directly to mounting clips (6) and ensure that the retaining tabs on the mounting clips (6) do not tear out of the door lining (1)	*110589035900
8	Remove door lining (1) upward from inner sealing rail and remove from inner door panel until inner door opener (7) is accessible on rear of door lining (1).	Installation  : Ensure that carrier (8) is seated correctly in corresponding openings in inner door panel.
9	Unhook Bowden cable on inner door opener (7) at rear side of door lining (1).
10	Remove door lining (1)
11	Install in the reverse order

Fig 2: Identifying Wedge Tool (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA