Replace brake fluid - AP42.00-P-4280CW

MODEL 204 

Fig 1: Identifying Brake Fluid Replacement

Courtesy of MERCEDES-BENZ USA

1. Filling and bleeding device
2. Cap
3. Venting hose
4. Brake fluid reservoir

	Remove/install
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
	Risk of poisoning  caused by swallowing brake fluid. Risk of injury  caused by brake fluid coming into contact with skin and eyes.	Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid.	AS42.50-Z-0001-01A
	Risk of injury  to skin and eyes caused by handling hot or glowing objects.	Wear safety gloves, protective clothing and safety glasses, if necessary.	AS00.00-Z-0002-01A
	Notes on repairs to brake system		AH42.00-P-0003-01A
	Brake fluid notes		AH42.50-P-0001-01A
	Clean
1	Clean cap (1) and brake fluid reservoir (2)
2	Unscrew cap (1).
3	Suction off brake fluid from the brake fluid reservoir (2)
4	Fill with new brake fluid up to the "MAX" mark in the brake fluid reservoir (2)		*BF42.10-P-1001-01J
5		Connect filling and bleeding unit (01) onto brake fluid reservoir (2) and switch on Pay attention to manufacturer's operating instructions.
		Brake fluid change unit with supply tank (10-20 l)
6	Allow brake fluid to flow out of the bleed screws	New brake fluid must escape free of bubbles via the bleed hose (02): ↓ Bleed the system.	AR42.10-P-0010-02CW
		Bleed screw to brake caliper	*BA42.10-P-1003-10J
		Bleed screw to brake caliper	*BA42.10-P-1002-12J
		Bleed screw to central clutch operator	*BA25.20-P-1001-01B
7	Install in the reverse order
8	Correct fluid level in brake fluid reservoir (2)		AP42.10-P-4210CW
	Check
9	Check brake system for leaks		AR42.10-P-0100-01V