Remove/install bottom parts of soundproofing - AR94.30-P-5300EW

MODEL 204, 207, 212, 218 (except 204.9) Vehicles with diesel engine 

Shown on model 212 

Fig 1: Identifying Soundproofing Bottom Components

Courtesy of MERCEDES-BENZ USA

Shown on model 212 with engine 642 

Fig 2: Identifying Soundproofing Bottom Components

Courtesy of MERCEDES-BENZ USA

Picture item, etc.	Work instructions
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
	Raise vehicle with vehicle lift
1	Middle bottom section of soundproofing	Vehicle without code (481) Underride guard Unscrew bolts (3, 4) and remove center bottom section of soundproofing (1). Rechargeable drill / screwdriver
2	Underride guard plate	Vehicles with code (481) Underride guard Unscrew bolts (3, 4) and remove underride guard plate (2).	*BA61.40-P-1001-01D
5	Front bottom section of soundproofing	On vehicles without code (481) Underride guard; first remove center bottom section of soundproofing (1). On vehicles with code (481) Underride guard; first remove underride guard plate (2). Unscrew bolts (6) and remove front bottom section soundproofing (5). An additional bolt is installed at the front in the center on model 218. Rechargeable drill / screwdriver
7	Rear soundproofing bottom section	Vehicles without code (481) Underride guard: Unscrew bolts (4, 8) and remove rear bottom section of soundproofing (7) Vehicles with code (481) Underride guard: Remove bolts (4, 8). Move underride guard plate (2) down by loosening bolts (3) and remove rear bottom section of soundproofing (7). Bolts (3, 4) Rechargeable drill / screwdriver	*BA61.40-P-1001-01D