Set low beam - AP82.10-P-8260-01CW
| AP82.10-P-8260-01CW | Set low beam | ||
| Risk of death
caused by high voltage levels present at xenon headlamps. Risk of explosion/fire hazard due to highly flammable substances in the area of damaged xenon bulbs Risk of injury due to UV light, hot components on xenon headlamps and glass splinters when xenon bulbs burst Risk of poisoning caused by inhalation of mercury vapors and by toxic salts and mercury compounds being ingested or coming into contact with skin |
Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart pacemakers) must never work on xenon headlamps. Switch off entire lighting system. Wear insulated safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure sufficient ventilation in the working area. | AS82.10-Z-0001-01A |
Shows model 204.0
Fig 2: Identifying Adjustment Screws For Height And Side Adjustments - Model 204.0/2 With Xenon Headlamps
Fig 3: Identifying Adjustment Screws For Height And Side Adjustments - Model 204.0/2/3 With Halogen Headlamps
Model 204.0/2/3 with xenon headlamps
Model 204.0/2/3 with halogen headlamps
Model 204.9
Check adjustment of low beam headlamps.
For the height adjustment the light-dark boundary of the light beam must be coincident with the horizontal separating line (1) in the headlamp aimer (01). When carrying out the lateral setting, the bent line (2) of the light bundle must lie below the central mark (3) and start on the horizontal broken line (1).
- Vehicles with xenon headlamps: If the headlamps are misaligned, connect STAR DIAGNOSIS subject to separate repair order and conduct zero position adjustment of axle and level sensors.
- Correct adjustment of low beam headlamps if necessary by turning the adjustment screws (H, S).