Remove/install bulbs of headlamp unit - AR82.10-P-1201CW

MODEL 204.0 / 2 

Fig 1: Identifying Headlamp Unit Bulbs Remove/Install Components

Courtesy of MERCEDES-BENZ USA

Figure item, etc.	Work instructions
	Risk of death  caused by high voltage at xenon headlamps. Risk of explosion/risk of fire  caused by highly flammable materials in the vicinity of damaged xenon bulbs. Risk of injury  caused by UV light, hot components at xenon headlamps and glass splinters produced by bursting xenon bulbs. Risk of poisoning  caused by inhalation of mercury vapors and by toxic salts and mercury compounds being ingested or coming into contact with skin	Do not come into contact with parts that are under high voltage. Persons with active electronic implants  (e.g. heart pacemakers) must never work on xenon headlamps. Switch off entire lighting system. Wear insulated safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure sufficient ventilation in the working area.	AS82.10-Z-0001-01A
	Do not touch the glass bulb elements of the bulbs with fingers, but use a soft cloth free of oil and grease; otherwise the bulbs can be damaged by overheating during operation
	Before changing a bulb, switch off the exterior lights in order to avoid a short circuit
	Switch off ignition and remove transmitter key or KEYLESS-GO start/stop button from electronic ignition lock control unit	KEYLESS-GO start/stop button only for vehicles with code (889) Keyless-Go.
E1e1, E2e1	Left high beam, right high beam	Remove housing cover (5), remove high beam socket (9). Pull left high beam (E1e1) or right high beam (E2e1) out of the high beam socket (9).
E1e2, E2e2	Left low beam, right low beam	For vehicles without code (614) Bi-xenon headlamp unit or without code (622) Intelligent Light System (right-hand traffic). Remove housing cover (1), remove low beam socket. Remove left low beam (E1e2) or right low beam (E2e2) from low beam socket.
E1e3, E2e3	Left front standing and parking lights, right front standing and parking lights	Remove housing cover (3), pull out standing and parking lights socket (7). Pull left front standing and parking lights (E1e3) or right front standing and parking lights (E2e3) out of standing and parking lights socket (7).
E1e5, E2e5	Left front turn signal light, right front turn signal light	Remove turn signal light socket (2). Remove left front turn signal light (E1e5) or right front turn signal light (E2e5) from turn signal light socket (2).
E1e10, E2e10	Left xenon bulb with integrated ignition module, right xenon bulb with integrated ignition module	For vehicles with code (614) Bi-xenon headlamp unit or code (622) Intelligent Light System (right-hand traffic). Remove housing cover (1), release mounting clip, pull out left xenon bulb with integrated ignition module (E1e10) or right xenon bulb with integrated ignition module (E2e10) and detach electrical connector (6).
E1e12, E2e12	Left front standing light 2, right front standing light 2	Remove housing cover (4), pull out standing lights socket (8). Remove left front standing light 2 (E1e12) or right front standing light 2 (E2e12) from standing light socket (8).