Retrofit comfort telephony antenna line - AN82.70-P-0008-02FH

Routing diagram 

Fig 1: Identifying Retrofit Comfort Telephony Antenna Line Routing Diagram

Courtesy of MERCEDES-BENZ USA

1. Remove insulation tape (10) and remove antenna line (1) from power supply wiring harness (2).
   Fig 2: Identifying Insulation Tape, Antenna Line And Power Supply Wiring Harness

   Courtesy of MERCEDES-BENZ USA
2. Position violet coupling (5) of antenna line (1), as shown, onto the center tunnel.
3. Route antenna line (1) through the opening in the floor covering onto the center tunnel.
4. Route antenna line (1), as shown, under right rear floor covering and fasten in place using felt tape.
   Fig 3: Identifying Violet Coupling And Antenna Line

   Courtesy of MERCEDES-BENZ USA
5. Route antenna line (1), as shown, along vehicle wiring harness (7) to multifunction antenna electrical connector (A28/11x1).
6. Fasten antenna line (1) using cable ties onto vehicle wiring harness (7).
7. Open cover (8) of bracket (9).
8. Connect black antenna line plug (10) with black multifunction antenna coupling (11) and thereby create multifunction antenna electrical connector (A28/11x1).
9. Close cover (8) of bracket (9).
   Fig 4: Identifying Antenna Line, Black Antenna Line Plug And Black Multifunction Antenna Coupling

   Courtesy of MERCEDES-BENZ USA