Retrofit wiring harness. - AZ82.70-P-0001-04CW

CAN wiring harness 

1. Expose vehicle floor chassis CAN potential distributor electrical connector (X30/30) in left front footwell cable duct.
   Fig 1: Identifying Vehicle Floor Chassis CAN Potential Distributor Electrical Connector

   Courtesy of MERCEDES-BENZ USA
2. Push catch tabs (7) of distributor rail (6) of potential distributor connector (CAN) outwards to the sides and slide lock (5) in direction of arrow.
3. Insert black, 2-pin coupling (8) of new CAN wiring harness (9) into a free slot in potential distributor connector (CAN).
4. Lock vehicle floor chassis CAN potential distributor electrical connector (X30/30). Route new CAN wiring harness (9) from right footwell over center tunnel in left footwell and fix in place.

   When routing the CAN wiring harness (9) ensure that no components are damaged or obstructed in their function.

   Fig 2: Identifying Sliding Lock

   Courtesy of MERCEDES-BENZ USA