Retrofit InCar Hotspot - AZ82.80-P-0002CW

MODEL 204.0 with CODE (228) Stationary heater with CODE (386) Comfort telephony with CODE (511) Audio 50 APS with DVD changer with CODE (512) COMAND APS with DVD changer with CODE (525) MB Audio 50 APS radio with CODE (527) COMAND APS with single DVD drive (with navigation) except CODE (460) Canada version except CODE (494) USA version except CODE (498) Japan version 

Fig 1: Identifying Incar Hotspot

Courtesy of MERCEDES-BENZ USA

	Removing
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1	Switch off ignition and remove transmitter key or KEYLESS-GO start/stop button from electronic ignition lock control unit	KEYLESS-GO start/stop button only on vehicles with code (889) Keyless-Go.
2	Remove side bolster of right rear seat backrest		AR91.12-P-1710CW
3	Remove right side trim panel from trunk		AR68.30-P-4600CW
4	Release rear SAM control unit with fuse and relay module	Only release rear SAM control unit with fuse and relay module, do not disconnect electrical connections.	AR54.21-P-1258CW
	Install
5	Retrofit InCar Hotspot (1) with holder		AZ82.80-P-0002-02CW
6	Retrofit wiring harness of InCar Hotspot (1)		AZ82.80-P-0002-01CW
		Wiring harness repair kit	Fig 2
7	Secure rear SAM control unit with fuse and relay module		AR54.21-P-1258CW
8	Install right side trim panel in trunk
9	Install side bolster of right rear seat backrest		AR91.12-P-1710CW
10	Perform function test of InCar Hotspot (1)	See operator's manual for InCar Hotspot (1).
11	Document retrofitted equipment via vehicle documentation (VeDoc)	Attach "InCar Hotspot retrofitted in accordance with AZ82.80-P-0002CW " under field organization texts for design group 82.

Fig 2: Identifying Wiring Harness Repair Kit (220 589 02 99 00)

Courtesy of MERCEDES-BENZ USA