Remove/install torsion bar on rear axle - AR32.20-P-0315P
WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2007 Mercedes-Benz C350, 2007 Mercedes-Benz C280, 2007 Mercedes-Benz C230, 2006 Mercedes-Benz C55, and 2006 Mercedes-Benz C350. However, it is still accessible from the selected car via links, so may be relevant.
MODELS 203, 209.3 /4
| Remove/Install | |||
|---|---|---|---|
| Risk of death. Death may result if vehicle slips or topples from the lifting platform. | Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Replace self-locking nuts and bolts. | AH00.00-N-0001-01A | ||
| 1 | Detach torsion bar (77) from left and right link rod (78) | *BA32.20-P-1001-04C | |
| 2 | Unscrew retaining bracket from torsion bar bracket on rear axle carrier (77d) | *BA32.20-P-1006-04C | |
| 3 | Take off torsion bar (77) | ||
| 4 | Detach link rod (78) | AR32.30-P-0630-01P | |
| *BA32.20-P-1005-04C | |||
| 5 | Install in the reverse order |
| Number | Designation | Model 203 | Model 209 | |
|---|---|---|---|---|
| BA32.20-P-1001-04C | Nut, connecting rod to torsion strut | NM | 40 | 40 |
| BA32.20-P-1005-04C | Bolt, connecting rod to wheel carrier | NM | 40 | 40 |
| BA32.20-P-1006-04C | Bolt, bracket to torsion bar bracket. | NM | 30 | 30 |