LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2008 >> SLK55 >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Rear Axle -- Testing & Repair -- 203 Chassis - 1 Of 2) >> Testing & Repair >> Remove/install rubber mount on track rod - AR35.20-P-0112-01P

Remove/install rubber mount on track rod - AR35.20-P-0112-01P

WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2007 Mercedes-Benz C350, 2007 Mercedes-Benz C280, 2007 Mercedes-Benz C230, 2006 Mercedes-Benz C55, and 2006 Mercedes-Benz C350. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Extraction And Installation Tool (203 589 01 43 00)
G04734642

    Remove 

  1. Using extraction and insertion tool SPECIAL TOOL (04e, 04f) press rubber mount (4b) out of the tie rod.
    Fig 2: Identifying Rubber Mount, Track Rod And Insertion Tool
    G04734643

    2. Install 

  2. Using the extraction and insertion tool SPECIAL TOOL (04e, 04f) press the rubber mount (4b) into the tie rod until the collar of the extraction and insertion tool, upper part (04e) abuts the boss on the tie rod.
    Fig 3: Identifying Rubber Mount And Insertion Tool
    G04734644
scientia non olet · About LEMON Manuals